Repositorio RUIdeRA

Nozzle rate of injection estimation from hole to hole momentum flux data with different fossil and renewable fuels

Mostrar el registro sencillo del ítem

dc.contributor.author Payri, R.
dc.contributor.author Bracho, Gabriela
dc.contributor.author Soriano, José Antonio
dc.contributor.author Fernández-Yáñez, Pablo
dc.contributor.author Armas, Octavio
dc.date.accessioned 2020-11-19T15:25:41Z
dc.date.available 2020-11-19T15:25:41Z
dc.date.issued 2020-11
dc.identifier.citation Fuel. 2020, 279 , 1-10 es_ES
dc.identifier.issn 0016-2361
dc.identifier.uri http://hdl.handle.net/10578/26731
dc.description.abstract Due to environmental problems, research on fuel economy and pollutant emissions in internal combustion engines has drawn the attention of automobile manufacturers and researchers. The diesel engine is one of the most efficient alternatives and one of the main areas of the study in these engines is spray mixing, recognized as a critical factor in combustion control and the reduction of its related contaminants. The studies about fuel sprays rely on experimental data of the rate of injection, which can only be obtained with high-cost equipment. The aim of this paper is to validate for different fuels a method for the determination of the rate of injection based on spray momentum measurements and the total injected mass. After a proper tuning of the test momentum flux device, the injection rate results were validated using the Bosch tube method. The technique was validated for four different fuels, diesel, biodiesel, GTL (Gas-to-liquid) and Farnesane, in order to identify the consequences of the fuel properties on the injection performance characteristics and the estimation method. The results of rate of injection following the procedures presented showed good accuracy when compared to experimental values. These methods can be employed to estimate this parameter when experimental facilities for this purpose are not available. es_ES
dc.format application/pdf es_ES
dc.language.iso en es_ES
dc.publisher Elsevier es_ES
dc.rights info:eu-repo/semantics/openAccess es_ES
dc.subject Diesel es_ES
dc.subject Farnesane es_ES
dc.subject GTL es_ES
dc.subject Biodiesel es_ES
dc.subject Rate of Injection es_ES
dc.subject Momentum Flux es_ES
dc.title Nozzle rate of injection estimation from hole to hole momentum flux data with different fossil and renewable fuels es_ES
dc.type info:eu-repo/semantics/article es_ES
dc.identifier.DOI 10.1016/j.fuel.2020.118404


Ficheros en el ítem

Ficheros Tamaño Formato Ver

No hay ficheros asociados a este ítem.

Este ítem aparece en la(s) siguiente(s) colección(ones)

Mostrar el registro sencillo del ítem

Buscar en RUIdeRA


Búsqueda avanzada

Listar

Mi cuenta